Spider Farmer’s cultivation desk rides alongside your grow team through fixture sizing, spectrum strategy, controller setup, and on-cycle tuning. Everything below is included in standard project scope; nothing is upsold as a separate service.
Send us a room sketch with ceiling height, rack layout, and target crop. We return a PPFD heatmap, uniformity index, and fixture count built around the DLI your crop actually needs, not a worst-case default.
We translate crop goals (seedling, veg, flower, finish) into spectrum presets and dimming curves your GGS controller can run unattended, with notes on when manual overrides actually help.
GGS controller setup, sensor calibration, and zone logic are walked through room by room, so the handover is not a PDF you read once and lose.
Retrofitting an operating facility is scheduled around your cultivation cycles, not our shipping windows. We stage fixture deliveries to match harvest rotations.
After two full cycles, we revisit PPFD data, environmental logs, and yield outcomes, then adjust spectrum presets and dimming schedules if the numbers argue for it.
Yes. Fixture and controller deliveries are staged room by room around your harvest rotation, so no canopy goes dark during the swap.
Before. Room layout, mounting height, and DLI targets drive fixture count; fixture count drives pricing. Otherwise quotes are just guesses.
GGS exposes a dry-contact and 0–10V interface layer for HVAC and irrigation triggers. Deeper integrations (BACnet, Modbus) are handled case by case in the commissioning phase.
Five years on the LED assembly and three years on drivers, with failed units cross-shipped from the nearest regional warehouse (US, EU, AU).
No upsells, no SKU-stuffing. Just a sized fixture count and a spectrum plan that matches your crop.